Replacing the service shifter in a Jeep Cherokee is something most drivers will encounter at some point during their ownership of the vehicle. It’s important to do this correctly and safely so that you don’t damage any components or create a hazardous situation while driving your Jeep Cherokee. With some basic tools, an understanding of the process, and following this guide, you can confidently replace the service shifter in your Jeep Cherokee.
What You Will Need
Before you start replacing the service shifter in your Jeep Cherokee, it’s important to make sure you have all of the necessary tools and supplies ready before getting started. You will need a set of wrenches or ratchets with both metric and standard sockets, a flathead screwdriver, an adjustable wrench or pliers set, a pair of safety glasses for eye protection from debris flying up from underneath the car as well as any other specialty tools that may be required for your particular model year. Additionally, make sure you have new replacement parts on hand such as linkage rods and gaskets for reassembly after removing the old shifter assembly.
Removing The Old Shifter
Before attempting to replace the service shifter in your Jeep Cherokee, it’s important to first remove the old one. This process is relatively straightforward and can be done in a few steps. First, disconnect the battery to avoid any potential electrical problems while working on the car. Then, lift up the center console and supporting brackets to gain access to the shifter itself. Once you have access, use your tools to carefully unscrew and remove all of the bolts that hold down and secure the shift assembly in place. With those removed, you can now disconnect all of the linkage rods from their corresponding mounting points before finally pulling out and removing the old shifter assembly from its place.
Installing The New Shifter
Now it’s time for installing your new service shifter into your Jeep Cherokee! With all of bolts removed from underneath the car as well as any linkage rods or mounting points disconnected from its old position, you can now begin putting together your new replacement shifter assembly by carefully slotting it into its new place underneath your vehicle’s center console. Make sure that everything lines up correctly before securing down with its accompanying bolts and screws so as not to leave any part loose after installation is complete. Once everything is lined up and secured, reattach each linkage rod to its corresponding mounting point so that the shifter operates as intended.
Additional Tips & Tricks
Replacing the service shifter in your Jeep Cherokee is a relatively straightforward process that can be done with basic tools and supplies mentioned earlier. However, there are a few tips and tricks to remember while attempting this repair task. First, it’s important to have patience when removing the old shifter assembly as some bolts may be harder to come by than others depending on their age or rust buildup around them. Also, it’s important to double-check all of your connections throughout the process so that nothing gets left behind or forgotten when reassembling afterwards. And finally, make sure you have new replacement parts on hand before starting any repairs so as not to miss any small components while working underneath your car.
In conclusion, replacing the service shifter in your Jeep Cherokee is a relatively simple task that anyone can do with just some basic tools and an understanding of the process outlined in this guide. With patience and care throughout each step of the way, you can confidently replace your service shift without worry and get back on the road with a reliable and safe Jeep once again.