Car Door Hinge Replacement – a Comprehensive Guide

Car Door Hinge Replacement - a Comprehensive Guide

When your Jeep doors start to sag or don’t line up properly, it’s time to replace the door hinges. Replacing door hinges is a relatively easy repair that can be done with basic hand tools. It should take about an hour or two, depending on the number of hinges you need to replace and your level of experience. This comprehensive step-by-step guide will show you how to replace the door hinges easily and effectively on your Jeep.

Tools and Materials Needed for Replacement

Before you start replacing your Jeep’s door hinges, make sure that you have all the necessary tools and materials for the job:

  • Ratchet set
  • Socket wrenches in various sizes
  • Adjustable wrench
  • Door hinge pins (number will depend on the number of hinges being replaced)
  • Grease or lubricant

Removing the Existing Door Hinges

Start by raising and propping open each door to give yourself enough room to work. Use a ratchet set or socket wrench to loosen any bolts holding both sides of each hinge together; use an adjustable wrench if necessary. Once these bolts are removed, you should be able to lift the hinge off the door. Remove any remaining bolts and take out the hinge pin. Make sure to save the screws and pins in a safe place for when it’s time to reattach them. You may also want to consider upgrading your door storage system. By using the Jeep door hangers, you can ensure safe and organized storage of your doors when not in use. To explore various options and find the right fit for your needs, refer to our comprehensive guide on the best Jeep door hangers.

Car Door Hinge Replacement - a Comprehensive Guide Installing the New Door Hinges

Use your new door hinges to replace the old ones, lining up each hole with its corresponding bolt hole in both the door and Jeep frame. Gently insert pins into each hinge, then use a ratchet set or socket wrench to tighten up any bolts that were removed earlier. Use a lubricant or grease on all moving parts of each hinge before reattaching them so they don’t get stuck while opening and closing your doors.

Before closing out your repair job, make sure that all the hinges are properly aligned with their respective bolt holes and that everything is secured tightly enough so your doors won’t sag or fall off. Test each door by opening and closing it several times to make sure they move as expected before fully securing them in place with their screws and pins. Finally, clean up any messes you may have left behind from replacing your Jeep’s door hinges.


Replacing your Jeep’s door hinges is a relatively straightforward job that anyone with basic hand tools and some mechanical know-how can do. Be sure to follow the steps in this guide carefully to ensure that your doors are properly aligned and secured when you’re done. With a little patience and time, you can have your Jeep doors working like new again in no time.

About the author

Andy Shane

Add Comment

Click here to post a comment